HVAC calculators
Size supply and return ducts from airflow and friction rate, the way a ductulator does, with the formula and assumptions shown.
Duct size calculator
Round and rectangular duct sizes from airflow and friction rate, with a CFM chart for every size.
Static pressure calculator
Total external static pressure from your readings, plus the friction rate for duct sizing.
AC tonnage calculator
Cooling capacity estimate by floor area and climate zone, with an honest check against real load calculations.
Furnace size calculator
Furnace BTU from floor area, climate zone and construction, converted to input by AFUE and checked against the ACCA Manual S range.
Heat pump size calculator
Heat pump tons from floor area and climate zone within the ACCA Manual S limits, with backup heat and balance point from your heat loss.
Mini split size calculator
Mini split BTU for each room by the ENERGY STAR sizing chart, the indoor head for each, and the outdoor unit for a multi-zone system.
BTU calculator
BTU to cool or heat a room by its size, sun, people and kitchen, the AC size to buy, and the same load in watts, kW and tons.
CFM airflow calculator
Airflow three ways: from system tonnage, from air changes per hour, and the ASHRAE 62.2 ventilation rate.
Flex duct CFM chart calculator
How much air each flex size really carries, stretched and compressed, against sheet metal.
Sizing a system, in order
Size the load first, then the equipment, then the air. Each step depends on the one before, so a furnace picked before the load is known is a guess.
- Estimate the load. The BTU calculator works room by room. The AC tonnage calculator gives a whole-house figure, with a climate-zone estimate checked against a Manual J style load.
- Choose the equipment. The furnace size calculator, the heat pump size calculator and the mini split size calculator take the load and apply the sizing rules each equipment type uses.
- Move the air. The CFM airflow calculator sets the airflow, the duct size calculator sizes each run by equal friction, the static pressure calculator checks the fan against the system, and the flex duct CFM chart shows what flexible duct can carry.
What the results are
These are planning figures. A load calculation done on site, by a contractor using Manual J, governs the equipment size, and the installer sets the airflow at the register. Use the numbers to compare options and to check a quote, not to replace the load calculation.